Build Year: 2003

Used For: Creels

Hull: GRP

Length: 6.33m

Beam: 2.54m

Draft: 0.47m

Licence:

Shellfish under 10m

Engine:

BETA 28kw de-rated to 21kw

Hydraulics:

Engine driven pto driving a Hydroslave hauler

Electronics:

1x Seiwa Explorer23 plotter,1 x Raymarine plotter/sounder,1 x Humminbird sounder,1x Icom GMDSS VHF,1 x NASA exhaust temperature alarm/temp gauge,1 x FURUNO GPS,1 X SONY marine stereo

Additional Information:

UPDATE..MCA out of water inspection complete and ok.
although her cert of registry has not been renewed there is still 5 months left to get her back on without huge issue. has been laid up for 2 years as am working abroad but has had engine and gearbox run up to temperature monthly. No VAT to pay.
Big refit in 2018/19 new propshaft, cutless bearing, propeller and mech shaft seal.
Engine was out, bilges painted, new sump fitted.
Boat totally rewired with tinned marine cables.
Rattly rudder pintles had bushings fitted.
Hydraulic tank removed and cleaned out.
Hydraulic pto and pump have just been overhauled, just waiting for the rubber coupling.
New hydraulic motor fitted to the hauler. New bearings fitted to the roller.
Deck-wash pump is off, just been overhauled.
New alternator 6 months ago.
Duplex fuel filter system made up and installed.
Fuel tanks cut open and cleaned, new hoses, valves etc fitted.
Auto bilge pump and high level alarm installed and working.
Manual emergency bilge pump in wheelhouse.
Inside of wheelhouse recently painted.
Dual control stations with Kobelt engine controls.
All nav and working lights are LED and work.
Small camera and underwater light fitted above propeller, small led screen in wheelhouse.
Boats MCA inspection well overdue and will be off the register by now. I have the go ahead from MCA for the sump to change her classification from decked to open vessel ,i have the sump made in stainless steel, just to fit it and buy pumps etc and block up the scuppers....work and personal commitments have prevented this from happening. I have a lot of the new safety gear already, PLB, flares, bucket etc etc.
Boat has been in Crail from new and has a good history.
Prefer to sell with licence but may sell without but i am not selling the licence on its own.
All underwater metal fittings are connected in a bonding system.
There is a wooden shooting tray also, removed for deck painting and touch ups along the working side of the deck.