Build Year:

Used For: new build

Hull: GRP

Length: 9.40m

Beam: 3.10m

Draft:

Licence:

Engine:

Hydraulics:

Electronics:

Additional Information:

For sale

32ft hull mould to take twin or single inboard engines with out drive legs, its a 6 birth cruiser hull mould.originally developed and designed by Fletcher this boat mould was made using professional resins and gel coats. Prior to being put into storage the Hull Mould was coated for protection. This is a full scale production mould having only 4 pulls from it as the original company that developed and commissioned it went bust, with one finished boat attending the Southampton boat show , one going to Ireland, and one shell was still in the mould when I bought it which was taken out and cut down to create a large rib hull. The original topside mould was damaged in transport so is therefore unavailable apart from some side panels and the radar arch. Also with the the mould there is internal shower tray mould, sink mould, steps plug and moulds, radar arch mould which are all included in the sale along with a ten tonne four wheeled bogey for moving around a yard or factory.

This is a serious piece of kit which I understand the original development of the boat mould and plugs cost in the region of 500k . The moulding once pulled off this mould could be utilised to create a trophy style American marlin fishing boat sea going cruiser,river cruiser the possibilities are endless. The hull produced is similar to that of a Fairline Targa or sunseeker. I am a boat builder by trade but unfortunately other projects have taken priority hence the reluctant sale of this fantastic production mould. I hand polished a couple of small areas to see how it would polish up and with very little effort it came up so it wouldn't take long with a machine polish. I have set a low reserve so someone will get a lot of kit for very little money.




Again, this would make a fantastic business opportunity.




Please phone Graham for any queries on 07973449095.