Build Year: 1972

Used For: Dredging, trawling, potting, netting, jigging

Hull: Wooden

Length: 8.30m

Beam: 3.00m

Draft: 0.70m

Licence:

Bivalve

Engine:

Perkins phaser 4 cylinder

Hydraulics:

Hydrolic pump run off front of engine, connections in deck for trawl winch and change over valve for Spencer Carter combo net hauler. Small 1/2 ton trawl winch (make unknown)

Electronics:

Dsc vhf, samyung sounder sdf310, flat screen monitor to plug in sodena etc,

Additional Information:

Boat is after going a lot of work including new drive shaft from gearbox to center thrust bearing, new center thrust bearing, new cutlass bearing, two new batteries, new anodes. All steel below waterline (keel and rudder) all blasted before painting. Boat is heavily built with teak on oak. Fully capped gunnels and transom in stainless steel. Fiberglass wheelhouse and whale back. Plastic sheeting port and strbd aft for dredges and strbd foward for potting/netting. Boat also wired for two 12v jigging machines. Very easy boat to handle any job single handed and very well layed out for all jobs with a change over within a couple of minutes. License is 2.5t and 21kwts. No panic in selling, no time waster please.! Would consider p/x for fast fisher (jigger)