Build Year: 1980

Used For: Work boat / dive platform

Hull: Steel

Length: 8.69m

Beam: 3.05m

Draft: 1.07m

Licence:

N/A

Engine:

6 cylinder ford 120 horse power and prm 2 to 1

Hydraulics:

N/A

Electronics:

Furuno radar colour sounder and VHF plus plotter (need rewired)

Additional Information:

28.5 foot ex-fishing boat for sale.

6 cylinder Ford 120 horse power and PRM 2 to 1

Furuno radar colour sounder and VHF plus plotter included (but will need rewired)

In good overall condition, with work carried out in 2020 including -

Fitted with work / recovery davit.

Repainted hull and deck.

Fitted new bilge pumps.

Boat was being used as a floating work platform and started regularly.

Boat has 'skegs' on the hull so it is easy to lift / transprt / store using a flat-bed trailer.

When the boat was bought in 2015 the following had just been completed:

Hydraulic gear box with vetus hydraulic steering which has all new pipe work
New ram sharft and seals
New wheel house, new decks, handrails, total re-wire
New transom, shaft re built, diesel tanks cleaned
Shot blasted inside and out then primed with 2 pack primer.

May consider swap for LWB or Luton Van, must be in VGC and of a similar value (no smaller Transit / Ducato sized vans, MUST be LWB).

Viewing welcome by arrangement in Kilmarnock.

Assistance can be given with collection or delivery (after full payment).

To answer a few questions:

The wheelhouse seems to be fibreglass / timber, not steel.

The overall height is 3.5m (sitting on a couple of timbers).

There are no lifting facilities available, you would need a HIAB or crane to lift it.

Weight is around 6 tonnes.