Build Year: 1980

Used For: Potting

Hull: GRP

Length: 5.70m

Beam: 2.20m

Draft: 0.60m

Licence:

Full shellfish licence 1.21ton 11kw

Engine:

Yanmar 3ym20, 3 cylinder 20hp

Hydraulics:

Seawinch stainless steel P-bracket hauler with group 2 clutch pump driven off the the front end of the engine.

Electronics:

Sitex fishfinder/sounder, Garmin Chartplotter/gps, Dsc VHF with built in GPS

Additional Information:

Some photos have been added of the fit out stage of the rebuild

For Sale due to a change in circumstances.

Available immediately

Boat was fully rebuilt from the bare hull up last year and into this year. It’s like a new boat. All new stern gear including tube and cutlass bearing. Now prop with rope cutter and shaft anode. New rudder and hydraulic steering assembly. New fuel tank, water separator filter and battery. New wheel house and moulded grp whaleback. Led deck lights and steaming flood light. Nav lights and anchor light. Boat is well set up with cat catcher, shooting table and the engine set low in midships. Engine is on new stainless engine beds with new coupling assembly. The engine it’s self is a low hour yanmar 3ym20 that was freshened up and gone over before installation. Very economical and quiet running being the 3 cylinder model. All throttle controls are new.

MCA passed may 2021
Very capable boat and a big boat for its size at just over 19ft.

Any questions or for specific photos etc please just ask.